polarisunder.blogg.se

1. GATEWAY MAC ADDRESS FOR VIRTUALBOX HOST ONLY NETWORK MAC OS X
2. GATEWAY MAC ADDRESS FOR VIRTUALBOX HOST ONLY NETWORK INSTALL
3. GATEWAY MAC ADDRESS FOR VIRTUALBOX HOST ONLY NETWORK WINDOWS 8.1

When you're done, you won't have any gateway lines in your interfaces file. Your virtual machines will still be able to communicate without a gateway setting if they are on the same network and VirtualBox is set up right.Įdit: To make sure you don't have a gateway on eth1 after a reboot, remove lines from your eth1 block so that it looks like this: auto eth1 If you're not getting a DHCP address for eth0, it's probably a misconfiguration in VirtualBox (like getting your adapters backwards).Įither way, you don't need a gateway or DNS settings assigned specifically for eth1 since that will be assigned by DHCP on eth0, so I would remove the gateway, dns-search, and dns-nameservers lines from your config. Without knowing more this is a bit of a shot in the dark, but my guesses are that either a) you are not getting a DHCP address on eth0, or b) your gateway settings for eth1 are messing with the default route DHCP assigned. It would be easier to troubleshoot your problem if you posted the results you are getting when trying to ping an external address (like the Google DNS servers you're using), the current network settings, and your routing table. So how do I ensure this configuration on boot? TX packets:16 errors:0 dropped:0 overruns:0 carrier:0

RX packets:16 errors:0 dropped:0 overruns:0 frame:0 TX packets:225 errors:0 dropped:0 overruns:0 carrier:0 RX packets:140 errors:0 dropped:0 overruns:0 frame:0 TX packets:10 errors:0 dropped:0 overruns:0 carrier:0 RX packets:2 errors:0 dropped:0 overruns:0 frame:0 UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1 I have included the output from the following commands below, to help in diagnostics:Įth0 Link encap:Ethernet HWaddr 08:00:27:75:47:64 I would greatly appreciate any help in this.

GATEWAY MAC ADDRESS FOR VIRTUALBOX HOST ONLY NETWORK MAC OS X

I have tried the same on Mac OS X with similar results.

GATEWAY MAC ADDRESS FOR VIRTUALBOX HOST ONLY NETWORK WINDOWS 8.1

The host is Windows 8.1 and the guest is Ubuntu Server 13.10. I have also swapped the NAT/Host-Only Network around between the 2 NICs.

I have tried switching the order in which the NICs appear in the /etc/network/interfaces file. If I then issue a service networking restart command, the networking begins to work as it should. The host/guest and guest/guest pairs of machines can ping each other, however the Internet isn't working as apt-get fails. When the guest boots up again, the Host-Only networking is working fine.

GATEWAY MAC ADDRESS FOR VIRTUALBOX HOST ONLY NETWORK INSTALL

Install the OS (Ubuntu Server 13.10) on each of them.Configure the 2nd NIC to use Hot-Only Networking.Create a guest machine with 2 networking interface cards (NIC).Change the IP address assigned to the host to 192.168.56.254.Switch off the DHCP Server feature of the Host-Only network to be used in this setup.Here's the procedure that I have followed so far: I also want the guests to have static IP addresses. I am trying to set up a set of guests in VirtualBox, such that each of them can access the Internet as well as be visible to each other and to the host.